Appearance
Getting started
EasyCP is a hosting control panel for AlmaLinux 9. One install gives you the web server, PHP, databases, mail, DNS, SSL and backups, managed from a browser.
What you need
| Operating system | AlmaLinux 9 (supported until May 2032). AlmaLinux 10 is not enabled yet. EasyCP isolates accounts and enforces each package's resource limits itself on plain AlmaLinux. To use CloudLinux instead (CageFS and LVE), install on AlmaLinux 9 and convert the server to CloudLinux 9; EasyCP detects it. |
| Processor | x86_64 (64-bit Intel or AMD). |
| Memory | Web server: 2 GB minimum, 4 GB or more recommended (sites, mail and databases all share it). Nameserver or backup server in a fleet: 1 GB minimum, 2 GB recommended. See Memory below. |
| Disk | At least 5 GB free. |
| Access | Root SSH access to a fresh server. |
| Licence | An EasyCP licence key, from your client area at easycp.net. |
Use a fresh server: the installer sets up the web server, database, mail and DNS software itself.
Memory
EasyCP is built to stay light. Measured on AlmaLinux 9 servers in November 2026, with nothing else running:
| Part | Typical memory |
|---|---|
| The panel and its broker | about 250 MB |
| MariaDB (the panel's database, plus the sites' on a web server) | 150 MB on a nameserver or backup server; on a web server Database Tuning gives it a quarter of the memory |
| PowerDNS (nameservers) | about 60 MB |
| Fail2Ban | about 30 MB |
| Spam filtering (web servers with mail) | about 300 MB |
| CrowdSec, if you install it | 150–500 MB (EasyCP caps it at 512 MB) |
On top of that, the operating system's updates need up to 800 MB for a minute while dnf works out what to install. That is why the panel's updater asks for 900 MB free before it starts.
- CrowdSec is not needed on a nameserver or backup server. The only thing it would watch there is SSH logins, which Fail2Ban already covers along with the panel login. Leave it off those servers (Plugins shows a note if it is installed).
- Small servers get compressed swap in memory. On a server with 4 GB or less and no swap of its own, EasyCP sets up zram: swap kept compressed in RAM, so nothing is written to disk. It only comes into use when memory runs short, such as during an update, and saves the server from having a process killed. Check it with
easycp-zram --status. If you add swap of your own, EasyCP takes its zram away. - If the server keeps using swap, the panel's bell says so: a short spike is what swap is for, but using it hour after hour means the server needs more memory, or less running on it.
Next
- Install EasyCP
- Keep it up to date
- Keep When the panel is down somewhere you can reach without the panel — that is what this site is for.
- Lost the admin password? Reset it from SSH.